Huck 3585PT Installation Tool
NOTE: This comes driectly from the manufacture and can take 45-90 days to get.
The package consists of a repair kit that includes:
• Hydraulic installation tool with 15ft hose • Power rig
• Bobtail 16mm installation nose assembly
• Pressure gauge
The Huck 3585PT Hydraulic Installation Tool goes beyond the 3585 by offering the capability to install Huck-Spin and Huck-Spin2 fasteners with a pass-through piston and end cap design. In addition, the 3585PT is fully compatible with Huck BobTail® fasteners. The stroke has been increased to 1.900” allowing the capacity to install and remove 20mm fasteners
Huck Model 3585PT In-line HydraulicInstallation Tool is designed to install all-16(1/2”) to -24 (3/4”) Huck-Spin, Huck-Spin2, and BOBTAIL Fasteners. This tool operates on 7400 psi (510 BAR) PULL and 3200 psi (220 BAR) RETURN pressures assupplied by Huck Hydraulic POWERIG® Models 918 or equivalent. Lengths and weights do not include Nose Assemblies. Except for a nose assembly, the tool is complete with handle, hoses, couplers and control cord ready to be attached to a HUCK POWERIG. The 3585PT tool is basically a cylinder and piston assembly. An unloading valve, designed to relieve the hydraulic pressure at both ends of the stroke, is positioned by the piston. The
3585PT does not have a pintail ejector as it is designed to install those fasteners without pintail break. The piston includes a pass through hole to allow the included T-wrench to install Huck-Spin collars. Proper PULL and RETURN pressures are important for the proper function of the Installation Tool and Nose Assemblies, and for the safety of
the operator. A Gauge Set-up T-124833CE is available for checking these pressures. Instructions are furnished with the Gauge and in applicable POWERIG® Instruction Manuals.
SPECIFICATIONS
POWER SOURCE: Huck POWERIG Hydraulic Unit | MAX OPERATING TEMP: 125°F (51.7°C) |
HOSE KITS: Use only genuine HUCK Hose Kits rated @ 10,000 psi working pressure. | MAX FLOW RATE: 2 gpm (7.5 l/m) |
HYDRAULIC FLUID: ATF meeting DEXRON III, DEXRON IV, MERCON, Allison C-4 or equivalent specifications. Fire resistant hydraulic fluid may also be used, and is required to comply with OSHA regulation 1926.302 paragraph (d): "the fluid used in hydraulic power tools shall be fire resistant fluid approved under schedule 30 of the US Bureau of Mines, Department of Interior, and shall retain its operating characteristics at the most extreme temperatures to which it will be exposed." | MAX INLET PRESSURE: 7400 psi, (510 bar) PULL CAPACITY: 45,668 lbs (203 KN) @ 7400 psi STROKE: 3585 1.81 inches (4.60 cm) 3585PT 1.90 inches (4.83 cm)
|
